This product is different from the traditional high-pressure mercury lamp curing equipment; the UV light produced by the traditional curing machine looks bright and has high heat. In fact, its spectrum is very wide. The real part of the energy in an effective curing UV spectrum is only part of its energy. A considerable part of the energy is produced in the visible (stray light) and heat, which causes serious damage to the operator's eyes and is easy to make. The hot deformation of the workpiece is irradiated by the point light source of LED, which emits high purity 365 nm monochrome ultraviolet light, which belongs to the cold light source; the temperature of the workpiece rises only about 3 degrees, the workpiece will not deform, and its energy is highly concentrated in a certain ultraviolet spectrum section with effective curing effect. This is the ultraviolet intensity of the point light source of UV-LED, although only about 200 mw, but its actual use effect and light. The main reason why the curing effect of high pressure mercury lamp with strength of 1000-2000 MW is similar is that the curing time is usually shortened to 0.5-5 seconds.

 

UVLED curing machine is the general name of all curing machines, which are divided into point, line, surface and other light sources.

 

1. Ultraviolet LED absolutely has the characteristics of long life of light source. The life of LED chips is 25,000-30,000 hours.

 

2. It is a safer and more environmentally friendly alternative to the traditional light source because it does not use toxic mercury and does not produce ozone.

 

3. Without preheating, the power of ultraviolet radiation can reach 100% and the irradiation intensity can reach 2000mW/cm2.

 

4. The new type of UV point light source equipped with special concentrating lens emits high light energy. The UVled curing machine dries instantaneously, the light output is stable, the uniform effect of irradiation is good, and the production efficiency is improved.

 

5. Independent control of multiple LED irradiation heads can be applied to multiple independent stations requiring single output simultaneously, which can effectively reduce equipment configuration. Multiple LED irradiation heads can also control sequential irradiation through computer programming mode, further support high-precision connection requirements, and reduce the time error of artificial operation.

 

Futansi produces UV LED, UV LED light source, UV LED light source, UV LED curing machine, UV LED curing lamp, UV LED irradiator, VLED point light source, UV LED line light source, UV LED surface light source, UV LED oven, UV LED curing furnace UV curing lamp, UV glue dryer.